Now there are many different ways and opportunities for accessing the network, one of these options is connecting the satellite Internet. If you decide to install satellite Internet on your computer and do not want extra costs for the work of the wizard, try to establish it yourself.
Necessary
- - Cable
- - Plate with a diameter of 90-120 cm
- - Bracket
- - Converter
- - DVB card
- - Heat shrink
- - Anchor
Instructions
Step 1
Make sure you have all the necessary equipment.
Step 2
Now set up the terrestrial channel. You will need DialUp, GPRS or some other kind of connection. Ask your ISP or operator how to set up your terrestrial channel.
Step 3
Now proceed with the installation of the DVB card. Install it on any free PCI slot. It is better to install it as far away from the TV tuner as possible, if you have one, so that it does not create any interference.
Step 4
An installation disc must be included with the DVB card. Insert it and install the driver for the card from it. On your computer, the DVB card should be recognized as a new network device.
Step 5
After you install the driver, a red icon should appear in the tray, which is located in the lower right corner near the clock. Right click on it and select Setup4PC.
Step 6
A window will open. In it, select Add and enter the name of the satellite Euteslat W6 there. Leave all other parameters as they are, without any changes. Click OK to confirm your selection.
Step 7
Now insert a new transponder. For the satellite Euteslat W6 we have chosen, select transponder 11345, speed - 28782, polarization H (which means Horizontal). If your satellite dish is correctly tuned, then a signal strength (or Signal Quality) bar should appear. Now we have finished configuring the transponder. Press the OK button first, then the Cloze button.
Step 8
To set up a proxy connection, in the Setup4PC window, select the Data Servises button. A window should open. In this window, select the name of the provider, to do this, click Add, and then enter the desired name.
Step 9
In the transponder window, which is on the right, select the Add button, type in the window that appears the transponder in which you selected the desired frequencies. Enter a name to display in the tray, click OK.
Step 10
Then enter PID List - enter 1024 in the box, click the Insert button. Click OK and then Close.
Step 11
Go to Start - Settings - Network Connections. Go to Properties. Select the General tab, select the TCP / IP protocol in it, click the Properties button. Enter the desired ip address. The subnet max is 225.225.225.0. Click OK.
Step 12
Download the GlobaX program, install it, run it and set the following settings:
[server]
port = 2001
log = client.log
[remote]
name = globax
server = (comes with the map)
login = (comes with the card)
passwd = (comes with the card)
speed_in = 100000
speed_out = 4096
mtu = 1500
mru = 1500
[local]
remote = globax
port = 127.0.0.1:3128
service_int = 0
[local]
remote = globax
port = 127.0.0.1:1080
service_int = 2
Save and close the document.
Step 13
Connect to the internet. That's it, this completes the setup.
